橡膠軟接頭又稱橡膠接頭、橡膠柔性接頭、軟接頭、減震器、管道減振器、減震器等。它是一種高彈性、高氣密性、中阻、耐候的管接頭。本產品具有橡膠彈性、高氣密性、耐介質性、耐候性、耐輻射性等特點。采用高強度、高熱穩定性、高溫度的滌綸簾子布，經高溫高壓模壓硫化而成。

Rubber soft joint is also called rubber joint, rubber flexible joint, soft joint, shock absorber, pipe shock absorber, shock absorber, etc.It is a kind of pipe joint with high elasticity, high air tightness, medium resistance and weather resistance.This product has rubber elasticity, high air tightness, resistance to medium, weather resistance, radiation resistance and other characteristics.Polyester cord fabric with high strength, high thermal stability and high temperature is vulcanized by high temperature and high pressure molding.

特點：內部密度高，壓力高，彈性變形好。

Features: high internal density, high pressure, good elastic deformation.

優點：減震、降噪、重量輕。

Advantages: shock absorption, noise reduction, light weight, non - toxic.

用途：與泵、閥門連接，振動大的管道，熱冷頻繁變化的管道。

Purpose: pump, valve connection, vibration of the pipeline, hot and cold frequent changes in the pipeline.

適用介質：海水、淡水、熱水、冷水、飲用水、生活污水、原油、燃料油、潤滑油、成品油、空氣、煤氣、蒸汽和粒狀粉末。

Applicable media: seawater, fresh water, hot water, cold water, drinking water, domestic sewage, crude oil, fuel oil, lubricating oil, refined oil, air, gas, steam and granular powder.

安裝說明：

Installation instructions:

1、安裝時嚴禁橡膠軟連接。

1. Rubber soft connection is strictly prohibited during installation.

2、管道必須有固定支架或支架，固定支架的受力必須大于軸向力。在垂直和架空安裝過程中，應在產品兩端安裝相應的固定支架和受力支架，以防在壓力下將工作拉出。

2. The pipe must have a fixed bracket or bracket, and the force of the fixed bracket must be greater than the axial force.In the process of vertical and overhead installation, the corresponding fixed support and stress support should be installed at both ends of the product to prevent pulling out the work under pressure.

3、安裝螺栓應對稱地、逐步地?cái)Q緊，以防止局部泄漏。

3. Mounting bolts shall be tightened symmetrically and gradually to prevent local leakage.